Everything about Counter Culture: How to Resurface Laminate Countertops for

Cut these strips with the keep piece off the lumber. Project the cutline inch past the edge (to account for the router bit's width). When utilizing a router, cut from left to right as you face the edge (and the tool is upright), to keep the bit from pulling. Adhere the side pieces Utilizing a chip brush, use contact cement to the back of the laminate strips for the counter's brief sides and onto the substrate sides.

Allow the contact cement on both parts to dry to the touch. Take a strip and position it over the side without letting it touch, making sure it's equally aligned all around. Working from one end to the other, stick the laminate to the substrate, smoothing it as you go.

Touch up uneven edges Using the router turned on its side, cut off the overhanging edges of laminate, running the bit counterclockwise around the edges. Retouch irregular edges with a file or sander, keeping it flat on top of the particleboard and pressing away from the laminate. With  Official Info Here  done, glue and cut the leading edge.

Custom Formica Laminate Countertops - Kitchen Magic

Keep the bit devoid of adhesive by periodically unplugging the router and soaking the bit in water. Cover laminate back and substrate with contact cement Turn the top laminate sheet facedown. Pour contact cement onto the back and, using a paint roller, spread out the adhesive over the entire sheet. Roll any excess onto the substrate.

Unknown Facts About Formica Countertops - HGTV

Permit the contact cement to dry to the touch on both parts. Laminate the top Lay wood scraps or dowels across the substrate every 12 inches or two. Flip the laminate so that it is adhesive-side down, and rest the sheet on top of the scraps without enabling it to touch the substrate.

Formica's Marble Countertops Basically Look Just Like the Real Thing

The Most Popular Countertops in 2017, Because We Know It's a Hard Decision  - Architectural Digest

Beginning in the middle, remove a scrap and press the laminate down. Exercising from the center, continue eliminating scraps and pushing the sheet into place, up until the entire sheet is adhered. Roll over the counter with the J-roller, using firm strokes. Using the trim router, cut off the excess around the boundary.